Inspection Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the electric power steering column sub-assembly has been replaced with a new one, perform torque sensor zero point calibration after performing the initialization of the torque sensor zero point value. Refer to CALIBRATION [08/2013 - ] .

HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.
The wire harness between the multiplex tilt and telescopic ECU and tilt motor is provided with the electric power steering column sub-assembly.