Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CLEARANCE WARNING ECU ASSEMBLY
1. Engage the 2 claws to install the clearance warning ECU assembly.
INSTALL ECU INTEGRATION BOX RH
1. Install the ECU integration box RH with the bolt and 2 nuts.
  Nut
  
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Bolt
  
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
2. Connect each connector.
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 13
INSTALL INSTRUMENT PANEL BOX DOOR COVER . Refer to INSTALLATION [08/2013 - ] - Step 14
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 1
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 16
INSTALL INSTRUMENT SIDE PANEL RH . Refer to INSTALLATION [08/2013 - ] - Step 17
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure as for the LH side. Refer to INSTALLATION [08/2013 - ] - Step 31 .
INSTALL COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure as for the LH side. Refer to INSTALLATION [08/2013 - ] - Step 32 .
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side. Refer to INSTALLATION [08/2013 - ] - Step 33 .
INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL . Refer to INSTALLATION [08/2013 - ] - Step 38
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .
INSTALL LUGGAGE TRIM SERVICE HOLE COVER . Refer to INSTALLATION [08/2013 - ] - Step 3
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [08/2013 - ]