LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> A6 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Cruise Control System (Diagnostic Codes & Circuit Tests)) >> Cruise Control System >> Circuit Tests >> Cruise SET Indicator Light Circuit [08/2013 - ] >> Procedure

Cruise SET Indicator Light Circuit [08/2013 - ]: Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM ACTIVE TEST USING TECHSTREAM (INDICAT. SET) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body / Combination Meter / Active Test.
    5. Check the cruise control SET indicator light by performing the Active Test.
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Indicat. SET Cruise control SET indicator light Cruise control SET indicator light ON / OFF -

      OK

      The cruise control SET indicator light goes on or off.

    6. Turn the power switch off.

    NG → See step   2 

    OK → See step   3 

  2. REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2013 - ] 
  3. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [08/2013 - ] 
scientia non olet · About LEMON Manuals