Installation [08/2013 - ]
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL VENTILATION VALVE SUB-ASSEMBLY
- Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.
Adhesive
Toyota genuine adhesive 1324, three bond 1324 or equivalent
- Using a 19 mm deep socket wrench, install the ventilation valve sub-assembly to the ventilation case sub-assembly.
Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
- Install the No. 2 ventilation hose to the ventilation valve sub-assembly.
- Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.
- INSTALL INTAKE MANIFOLD
Refer to INSTALLATION [08/2013 - ]