Installation [08/2013 - ]
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE WATER PUMP ASSEMBLY
- Install a new gasket to the engine water pump assembly.
HINT:
Be sure to clean the contact surfaces.
- Install the engine water pump assembly with the 5 bolts.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
- Connect the connector to the engine water pump assembly.
- Connect the clamp.
- Install a new gasket to the engine water pump assembly.
- ADD COOLANT (for Engine) See step 2
- INSPECT FOR COOLANT LEAK (for Engine) . Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1