LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> A6 Premium Plus >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head, VALVETRAIN- CYMC, CYRB, CYRC, CWPB, DAXB, DAXC, CJEB, CJED, CJEE, CNCD, CNCE, CUHA, CUJA, CNCB, CUHB, DAYB, CYGA, CYNB, CYPA, CYPB, CYYA, CVJA >> 15 Cylinder Head, VALVETRAIN >> VALVETRAIN >> Camshaft, Removing And Installing >> Installing >> Installing the Camshaft Timing Chain

Installing the Camshaft Timing Chain

GWWN15-10944Courtesy of AUDI OF AMERICA, LLC

-- Engage the camshaft timing chain with the painted links -arrows- on the camshaft pins.

-- Place the camshaft timing chain on the intake camshaft, exhaust camshaft and the crankshaft. Position the painted chain links -arrows- on the marks on the chain sprockets.

GWWN15-10952Courtesy of AUDI OF AMERICA, LLC

-- Install the guide rail -2- and tighten the bolts -1-.

GWWN15-10943Courtesy of AUDI OF AMERICA, LLC

-- Install the upper glide rail -1-.

GWWN15-10962Courtesy of AUDI OF AMERICA, LLC

I - Turn the exhaust camshaft slightly in direction of -arrow A- using the :T40266  and push the :T40271/1  out of the chain sprocket splines -B-.

II - Release the camshaft in the direction -arrow C-, until the timing chain touches the glide rail -1-. Hold the camshaft in this position, install the tensioning rail -2- and tighten the bolts -3-. Release the camshaft.

-- Turn the intake camshaft with the :T40266  in direction of -arrow 1- until the :T40271/2  can be pushed out of the chain sprocket splines in direction of -arrow 2-. Release the camshaft.

GWWA15-11429Courtesy of AUDI OF AMERICA, LLC

-- Remove the :T40271/1  and :T40271/2  .

-- Install the bolts -arrows- and tighten them. Tightening specification -item 4-  OVERVIEW - CYLINDER HEAD.

GWWA15-11390Courtesy of AUDI OF AMERICA, LLC

-- Coat the holes -arrows- with engine oil.

GWWA15-11798Courtesy of AUDI OF AMERICA, LLC

-- Check if the adapter sleeve -1- is installed. (Not present on every bearing bracket.)

GWWA15-11240Courtesy of AUDI OF AMERICA, LLC

-- Attach the bearing mount and install the bolts -arrows- all the way by hand.

-- Remove the :T40267  .

GWWA15-11392Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bearing bracket bolts. Refer to Figure.

-- Install the chain tensioner -2-. The wire clip must come in to contact with the oil pan upper section opening -arrow-. Tighten the bolt -1- and remove the :T40011  .

GWWN15-10947Courtesy of AUDI OF AMERICA, LLC