Wheel Bearing In Curb Weight Position, Lifting Vehicles With Coil Spring

WARNING: This page is about a different car, the 2021 Audi S4 and 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine and Gearbox Jack :VAS6931
Tensioning Strap :T10038
Engine/Gearbox Jack Adapter - Wheel Hub Support :T10149

NOTE:

All bolts on chassis components with bonded rubber bushings must be tightened in curb weight position. Refer to VEHICLES WITH COIL SPRINGS, CHECKING THE CURB WEIGHT POSITION FOR AXLE ALIGNMENT .

Bonded rubber bushings have a limited range of rotation. Axle components with bonded rubber bushings must be brought into the position they will be in when driving before they are tightened (curb weight position).
Otherwise, the bonded rubber bushing will have tension, which will reduce the service life.
By raising the corresponding suspension using the :VAS6931 and :T10149 , this position can be simulated on the hoist.

Procedure

Fig 1: Determining Height Dimension -a-

Courtesy of AUDI OF AMERICA, LLC

-- Before starting the procedure, determine the measurement -a-, for example using a tape measure, from the center of the wheel to the lower edge of the fender/wheel housing.

NOTE:

The measurement must be taken in curb weight position. VEHICLES WITH COIL SPRINGS, CHECKING THE CURB WEIGHT POSITION FOR AXLE ALIGNMENT

-- Note the measurement. This will be needed when tightening the bolts/nuts.

-- Remove the wheel. Refer to WHEELS AND TIRES .

Courtesy of AUDI OF AMERICA, LLC

-- Turn the wheel hub, until a wheel bolt hole is at the top.

-- Install the :T10149 with a wheel bolt -2- on the wheel hub.

NOTE:

Ignore item -1-.

NOTE:

Tightening of the applicable bolts/nuts must only occur if the dimension between the center of the wheel hub and the lower edge of the fender/wheel housing that was measured before starting the procedure has been attained.

WARNING:

Risk of accident!

A vehicle that is not secured can slide off the hoist.

-- Insert the :T10149 in the :VAS6931 and lift the wheel bearing housing slightly.

Fig 2: Dimension Between Wheel Hub Center & Lower Edge Of Wheel Housing

Courtesy of AUDI OF AMERICA, LLC

Before the respective suspension is lifted up to the curb weight position, the vehicle must be tied down using the :T10038 on the :VAS6931 .

-- Lift the wheel bearing housing, until the dimension -a- has been reached.

WARNING:

Risk of accident!

Do not lift or lower the vehicle when the :VAS6931 is under the vehicle.
Do not leave the :VAS6931 under the vehicle any longer than necessary.

-- Tighten the applicable bolts and nuts.

-- Lower the wheel bearing housing.

-- Move the :VAS6931 to the side

-- Remove the :T10149 .

Tightening Specifications

Refer to WHEELS AND TIRES