Input Shaft Seal, Replacing: Overview

Special Tools And Workshop Equipment Required 

• Puller - Crankshaft/Power Steering Seal :T20143 
• Thrust Piece :T40300 

• Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .

-- With the :T20143  carefully remove the seal -arrow- from the housing.

Courtesy of AUDI OF AMERICA, LLC

-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the new seal to the stop using the :T40300  .

Courtesy of AUDI OF AMERICA, LLC

-- Install the clutch. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .