Drive Axle, Pressing Out Of Wheel Bearing

Special tools and workshop equipment required

NOTE:

If the drive axle cannot be pulled out of the wheel bearing, then the drive axle can be pushed out of the wheel bearing using the :T10520 .

Procedure

Fig 1: Locating Thrust Piece

Courtesy of AUDI OF AMERICA, LLC

-- Check if the thrust piece -1- is inserted in the :T10520 .

-- To press out the drive axle -3-, secure the :T10520 -1- on the wheel hub with three wheel bolts -2-.

Fig 2: Identifying Remover T10520

Courtesy of AUDI OF AMERICA, LLC

-- Follow the specified sequence exactly.

Fig 3: Identifying Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

I -

Tighten the knurled nut -1- hand-tight.

II -

Only turn the bolt -2- using a wrench to remove the drive axle

NOTE:

When pressing out or setting back the drive axle, the spindle must be turned back in the starting position so the hydraulic function can be used.