Contact Corrosion
WARNING: This page is about a different variant/trim than selected.
Contact corrosion can occur if incorrect fasteners (bolts, nuts, washers, etc.) are used.
For this reason, only fasteners with a special surface coating may be installed.
In addition, rubber or plastic parts and adhesive are made of materials that do not conduct electricity.
If there are doubts about whether parts can be used or not, use new parts.
NOTE:
Only original replacement parts are recommended. They are checked and are compatible with aluminum.
The use of Audi accessories is recommended.
Damage resulting from contact corrosion is not covered by the warranty.