Testing Values and Process Specifications Table:
WARNING: This page is about a different variant/trim than selected.
| Fastening Element | Tightening specification [Nm] |
|---|---|
| Wheel Bolts | 120 |
The adapter to loosen/tighten the anti-theft wheel bolts is located in the vehicle tool kit.
Procedure:
-- Remove the wheel bolt caps.
-- Tighten the wheel bolts diagonally to the specified tightening specification. Refer to Testing Values and Process Specifications Table: for the testing values and process specifications table.
-- Press the wheel bolt caps on all the way using tool : 8Z0.012.287 .
-- If the adapter from the vehicle tool kit was used for the anti-theft wheel bolts, put the adapter in the vehicle tool kit.