Ignition Coils, Lubricating

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Procedure:

-- Grease the seal tube -arrow- of the ignition coil all around with silicone paste. The bead must be 1 to 2 mm thick.

Fig 1: Apply A Thin Bead Of Silicone Grease All Around The Sealing Hose

Courtesy of AUDI OF AMERICA, LLC

NOTE:

New ignition coils are delivered already lubricated. It is not necessary to lubricate them again.

Refer to the Parts Information for silicone paste to be used.

CAUTION:

Incorrect lubricant increases the risk of destroying the ignition coils.

- Only use the silicone paste approved here.