4-Cylinder Gasoline Engine, 1.8L TFSI / 2.0L TFSI (Version 2)
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit: SMN372500
Removal Procedures:
-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
Procedure:
-- Place the oil drip tray under the engine oil pan.
-- Open the plug -arrow- for the oil pan.
-- Drain the engine oil from the oil pan.
-- Replace the plug seal.
-- Tighten the plug until it stops.
Additional installation procedures occur in reverse order.
NOTE:
For the 4-cylinder gasoline engine 1.8L TFSI /2.0L TFSI, there are different versions of the oil drain plug. Refer to 4-CYLINDER GASOLINE ENGINE, 1.8L TFSI / 2.0L TFSI (VERSION 1) .