Wheel Bearing Unit, Removing And Installing, Fwd Vehicles: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

-- Carefully slide the wheel hub/wheel bearing unit onto the axle stub.

Make Sure That Wheel Hubs/Wheel Bearing Unit Does Not Tilt!

-- Tighten using a new multi-point socket head bolt -1-.

Fig 1: Identifying Wheel Hub/ Bearing Unit

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Never use an impact wrench when tightening the bolt -1- using the : T10162A .

NOTE:

First tighten the bolt to the given tightening specification using the torque wrench.

Use a rigid wrench to apply additional torque angle.

-- Install the new dust cap with the : 3241/4 -1-

Fig 2: Dust Cap

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Always replace dust caps.

Damaged dust caps allow moisture to enter. Therefore, always use the tool shown.