Stabilizer Bar, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
Applies to Audi TT Roadster
-- Remove the right rear wheel. Refer to WHEELS AND TIRES .
-- Remove the right rear coil spring. Refer to SPRING, REMOVING AND INSTALLING .
Applies to Audi TT Coupe
-- Remove the muffler and set aside. Refer to MUFFLER, REMOVING AND INSTALLING [CNTC, CYFB] or MUFFLER, REMOVING AND INSTALLING [DAZA, DNWA] .
Applies to All
-- Remove the left and right nut -1-.
-- Remove the coupling rod -2- from the stabilizer bar -3-.
-- Remove the left and right bolts -arrows-.
-- Remove the stabilizer bar -1- from the subframe -2-.
Applies to Audi TT Roadster
-- Guide out the stabilizer bar to the right side.