Overview - Tie Rod

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Tie Rod

Courtesy of AUDI OF AMERICA, LLC

Subframe
Bolt
- Replace after removing
Wheel Bearing Housing
Tie Rod
- The tie rod for an AWD vehicle is illustrated
- Removing and installing. Refer to TIE ROD, REMOVING AND INSTALLING .
Bolt
- 70 Nm +180°
- Replace after removing
- Tighten the threaded connections in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
Nut
- 70 Nm +180°
- Replace after removing