LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 74 (Wheels, Tires And Wheel Alignment (Wheel And Tire Guide General Information) [Coupe]) >> 44 Wheels, Tires And Wheel Alignment >> Tires, Mounting >> Tire And Wheel Radial And Lateral Run-Out, Checking >> Tire And Wheel Radial And Lateral Run-Out, Checking, Tolerances >> Notes

Tire And Wheel Radial And Lateral Run-Out, Checking, Tolerances: Notes

WARNING: This page is about a different variant/trim than selected.

Radial and lateral run-out occur when the wheel and tire are not running precisely true.

For technical reasons, 100% true running is not possible.

Therefore the manufacturers of these components allow a precisely specified tolerance.

Mounting the tire in a unfavorable position on the wheel can be the cause for exceeding the maximum allowed tolerance for wheel with tire.

The table shows the maximum permissible tolerance values for the wheel with mounted tire.

scientia non olet · About LEMON Manuals