Valve, Removing And Installing, Rubber Valve

WARNING: This page is about a different variant/trim than selected.

Make sure wheel rim is clean.

-- Using the Valve Fitting Tool : VAS6459 -1-, insert a new tire valve.

Fig 1: Identifying VAS -6459- To Install New Tire Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the valve insert.

-- Inflate the tire to approximately 3 to 4 bar; the tire bead must slip audibly over the rim hump when doing this.

-- Install the valve insert.

-- Fill the tire to the specified pressure.

CAUTION:

Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseperable connection and cannot be separated again.

-- Balance the tire.