LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 74 (Wheels, Tires And Wheel Alignment (Wheel And Tire Guide General Information) [Coupe]) >> 44 Wheels, Tires And Wheel Alignment >> Rim Information >> Valve, Removing And Installing >> Valve, Removing And Installing, Metal Valve >> Installing

Valve, Removing And Installing, Metal Valve: Installing

WARNING: This page is about a different variant/trim than selected.
NOTE:

Only apply the specified torque to tighten the nut for the metal valve.

Tightening more is not permitted because it damages the seal.

-- Tighten the nut -1- of the metal valve.

Fig 1: Identifying Metal Valve
GWWN44-10443Courtesy of AUDI OF AMERICA, LLC

-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.

-- Install the Tire Pressure Monitoring Sensor --.

-- Fill the tire to the specified pressure.

CAUTION:

Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseperable connection and cannot be separated again.

scientia non olet · About LEMON Manuals