Drip Rail, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• The vehicle and the drip rail must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04  and let dry.

-- Check the seals -1 and 3- and the clip -2- for damage.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the protective film from the adhesive tape.

-- Position the drip rail and press the clips on until they engage audibly.

• Vehicle resting time is at least 30 minutes at room temperature.