Rear Impact Guard, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• The vehicle and the impact guard must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04  and let dry.

-- Remove the protective foil from the adhesive tapes -2 and 5-.

Courtesy of AUDI OF AMERICA, LLC

-- Place the rear impact guard -1- on the hood -3- to do so push the securing tabs -4- in the mounts -arrows-.

-- Press in the rear impact guard along the entire length using the : 3356  .

• Vehicle resting time is at least 30 minutes at room temperature.