LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 71 (Hood, Lids [Coupe]) >> 55 Hood, Lids >> Fuel Filler Door Unit >> Fuel Filler Door Unit, Removing And Installing >> Removing

Fuel Filler Door Unit, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Free up the emergency release cable in the luggage compartment.

-- Detach the rear section of the right wheel housing liner and push it aside. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Free up the drain hose -1- -arrows-.

GWWA55-11080Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuel filler door unit trim. Refer to FUEL FILLER DOOR UNIT TRIM, REMOVING AND INSTALLING .

-- Release the fuel filler door unit at the markings.

-- To do so puncture the respective marks designated with the -arrows- with a small screwdriver -1-.

GWWA55-11079Courtesy of AUDI OF AMERICA, LLC

-- Lightly move the screwdriver from the center of the fuel filler door unit outward to release the catches -2- underneath it.

-- Remove the fuel filler door unit with the drain hose gradually from the opening.

-- Disconnect the connector.

-- Remove the fuel filler door unit while guiding out the emergency release cable.