Speaker Trim, Removing And Installing
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Wedge Set: T10383
Removing the Exterior Speaker Trim:
CAUTION:
There is a risk of damaging the speaker trim.
- Proceed very carefully when removing and Installing.
-- Carefully detach the speaker trim -1- using the : T10383/1 along the seam in direction of -arrow-, to do this push the wedge approximately 2 mm in the seam under the speaker trim.
Removing the Center Speaker Trim:
CAUTION:
There is a risk of damaging the speaker trim.
- Proceed very carefully when removing and Installing.
-- Carefully detach the speaker trim -1- using the : T10383/1 along the seam in direction of -arrow-, to do this push the wedge approximately 2 mm in the seam under the speaker trim.
-- Insert a long screwdriver under the speaker trim at the front, and detach the front clips.
Installing
Install in reverse order of removal.