Coolant Pump, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Depending on the model, preliminary work may be required. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Loosen the bolts -1 through 4-, and remove the coolant pump from the Engine Temperature Control Actuator -N493-.

Fig 1: Coolant Pump - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the toothed belt from the coolant pump.

NOTE:

If the coolant pump cannot be removed as described, remove the Throttle Valve Control Module -GX3-. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING .