Coolant Pump Toothed Belt, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

Note the toothed belt sprocket installation location ) OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT, ENGINE WITH Engine Temperature Control Actuator -N493-.
Replace the bolts that were tightened with an additional turn after removing them.

-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .