Additional Side Airbag Safety Precautions

WARNING: This page is about a different variant/trim than selected.

CAUTION:

We recommend using original equipment seat covers.
Seat covers or protective covers that are not specially approved for use on Audi seats with side airbags must not be used.
Do not cut the backrest material in side airbag area.
When installing, the seam in side airbag region must run straight.
All upholstery clips must be replaced (metal and plastic clips).
Using original equipment upholstery clips is recommended.
During installation, all upholstery clips must be placed in the same place they were when they were removed.
If cover is damaged (with rips, burned holes, etc.) in side airbag region, it must be replaced for safety reasons so that airbag deploys correctly.
Do not repair the backrest cover in the side airbag area (because of special materials and strictly defined seams).
Always replace the backrest cushion if the side airbag deploys.
After an accident, all damaged parts must be replaced. If no airbag unit damage is detected, the airbag unit can still be used.
If side airbag units are replaced, the new side airbag number sticker should be removed and placed over the old sticker on the seat pan.
Do not poke the cover with an upholstery needle or other sharp objects near the airbag, the Front Passenger Seat Occupant Sensor -G128- or the passenger occupant detection system mat.