Rear Axle Camber, Adjusting
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1332 40-200Nm:VAG1332
- 18 mm socket from the Shock Absorber Set:T10001
- Insert Tool - 18mm:T10179
Procedure
-- Remove the nut -A- on the upper control arm threaded connection from the subframe and loosely install a new nut.
-- Set the camber by turning the eccentric bolt -B- using the 18 mm socket from the :T10001 .
- To turn the eccentric bolt -B-, turn the hex head at the "top of the bolt".
NOTE:
The maximum adjustment range is 90° to left or right of center position.
-- Tighten the nut -A- using the :T10179 .
-- Use the :T10179 -1- as shown.
-- After the nut -A- is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK