Brake Caliper, Replacing, 1LK/1LH TTS: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1332 40-200Nm :VAG1332
- Brake Pedal Actuator :VAG1869/2 .
- Bleeder bottle from the Brake Charger/Bleeder Unit :VAS5234
- Plugs from the Assembly Part Set :5Q0 698 311
- M10 Plugs
- M12 Plugs
WARNING:
- Do not damage the brake hose and brake line.
- Do not bend the brake line past the specified form.
- A damaged brake hose or a damaged or bent brake line must be replaced.
NOTE:
Clean bolts before reusing.
Replace damaged bolts.
Always replace self-locking bolts.
NOTE:
The brake caliper is removed and disconnected from the hydraulic system in the following description. The brake hose is removed.
Only bleed the brakes on the wheel from which the brake caliper was removed and the brake line was loosened. If the brake pedal still feels "soft", completely bleed the brakes. Refer to HYDRAULIC SYSTEM, BLEEDING .