Brake Caliper, Removing And Installing, 1LK/1LH TTS: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the affected front wheel. Refer to Wheels and Tires .

-- Disconnect the connector -arrow- for the brake pad wear sensor contact on the brake caliper.

NOTE:

For easier removal of the brake caliper from the brake rotor, push the brake pad -3- back slightly with suitable pliers -1-, as shown in the illustration.

Image is an example

Courtesy of AUDI OF AMERICA, LLC

To prevent damage to the paint coat on the brake caliper, place a piece of rubber -2- between the pliers and brake caliper.

-- Remove the bolts -1- for the brake caliper.

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake caliper.

-- Hang the brake caliper on the body using a suitable wire.

CAUTION:

Danger of damaging the brake hose.

Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.

Risk of damaging the brake caliper piston.

Do not press the brake pedal when the brake caliper is removed.

WARNING:

Do not damage the brake hose and brake line.
Do not bend the brake line past the specified form.
A damaged brake hose or a damaged or bent brake line must be replaced.