Brake Rotor, Removing And Installing, Pr 1JL, 1ZD: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Before reusing brake rotors check for wear and damage.
- Brake rotor wear limit. Refer to TECHNICAL DATA .
NOTE:
Clean bolts before reusing.
Replace damaged bolts.
Always replace self-locking bolts.
WARNING:
If a brake rotor is damaged or worn, check the other brake rotors for damage and wear.
-- Thoroughly clean the brake rotor and hub contact surfaces and free them of corrosion.
-- Place the brake rotor on the wheel hub.
NOTE:
Do not tilt the brake rotor when mounting it on the wheel hub.
-- Tighten the bolt -arrow-.
-- Install the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, PR 1JL, 1ZD .
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly seat in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.