Brake Pads, Removing And Installing, Pr 1JL, 1ZD: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Label the brake pads that will be used again when removing. Install in the same position, otherwise the braking effect will be uneven.
-- Remove the affected front wheel. Refer to Wheels and Tires .
-- Remove the bolts -arrows- by counter-holding at the guide pins -1 and 2-.
-- Remove the brake caliper.
CAUTION:
Danger of damaging the brake hose.
- Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
- Replace the brake hose if damaged.
Risk of damaging the brake caliper piston.
- Do not press the brake pedal when the brake caliper is removed.
WARNING:
- Do not damage the brake hose and brake line.
- Do not bend the brake line past the specified form.
- A damaged brake hose or a damaged or bent brake line must be replaced.
-- Hang the brake caliper on the body using a suitable wire.
-- Disconnect the connector -arrow- for the brake pad wear sensor contact on the brake caliper.
-- Remove the brake pads.