Brake Caliper, Replacing, Pr 1JL, 1ZD: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench 1332 40-200Nm :VAG1332
- Brake Pedal Actuator :VAG1869/2 .
- Bleeder bottle from the Brake Charger/Bleeder Unit :VAS5234
WARNING:
- Do not damage the brake hose and brake line.
- Do not bend the brake line past the specified form.
- A damaged brake hose or a damaged or bent brake line must be replaced.
NOTE:
Clean bolts before reusing.
Replace damaged bolts.
Always replace self-locking bolts.
Plugs from the Assembly Part Set :5Q0 698 311
- M10 Plugs
- M12 Plugs
NOTE:
In the following description the brake caliper is removed and disconnected from the hydraulic system. The brake hose is removed.
NOTE:
Only bleed the brakes on the wheel which the brake caliper was removed and the brake line was loosened. If the brake pedal still feels "soft", completely bleed the brakes.