Brake Caliper, Removing And Installing, Pr 1JL, 1ZD: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the affected front wheel. Refer to Wheels and Tires .
-- Disconnect the connector -arrow- for the brake pad wear sensor contact on the right brake caliper.
NOTE:
For easier removal of the brake caliper from the brake rotor, push the brake pad -3- back slightly with suitable pliers -1-, as shown in the illustration.
To prevent damage to the paint coat on the brake caliper, place a piece of rubber -2- between the pliers and brake caliper.
-- Remove the bolts -arrows- and carefully remove the brake caliper with the brake carrier and the installed brake pads from the brake rotor.
CAUTION:
Danger of damaging the brake hose.
- Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
- Replace the brake hose if damaged.
Risk of damaging the brake caliper piston.
- Do not press the brake pedal when the caliper is removed.
WARNING:
- Do not damage the brake hose and brake line.
- Do not bend the brake line past the specified form.
- A damaged brake hose or a damaged or bent brake line must be replaced.
-- Hang the brake caliper on the body using a suitable wire.