Brake Caliper, Removing And Installing, Pr 1JL, 1ZD: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
NOTE:
Clean bolts before reusing.
Replace damaged bolts.
Always replace self-locking bolts.
WARNING:
Health Risk.
- Do not blow out brake system with compressed air.
NOTE:
Use only mineral spirits to clean the brake caliper.
-- Clean the brake caliper.
-- Carefully slide the brake caliper with the brake carrier and the brake pads installed over the brake rotor.
NOTE:
Clean bolts before reusing.
Replace damaged bolts.
Always replace self-locking bolts.
-- Tighten the bolts -arrows-.
NOTE:
Make sure the brake hose is routed correctly.
Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.
WARNING:
- Do not damage the brake hose and brake line.
- Do not bend the brake line past the specified form.
- A damaged brake hose or a damaged or bent brake line must be replaced.
-- Connect the connector -arrow- for the brake pad wear sensor contact on the brake caliper.
WARNING:
Risk of accident!
- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly seat in their respective position.
- Make sure the brakes are working correctly before driving the vehicle for the first time.