Dust Cap, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

To clean only use mineral spirits.

-- Clean the surfaces on the pistons and brake caliper using mineral spirits and then dry.

-- Place the protective cap in the groove -arrow- on the piston.

Courtesy of AUDI OF AMERICA, LLC

-- Install the piston clockwise -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Push the protective cap onto the brake caliper using the :T10502 -2- and :T10145 -1- so that the protective cap is touching the brake caliper all the way around.

Courtesy of AUDI OF AMERICA, LLC