Brake Master Cylinder, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
WARNING:
- Do not damage the brake hose and brake line.
- Do not bend the brake line past the specified form.
- A damaged brake hose or a damaged or bent brake line must be replaced.
NOTE:
Replace the nuts after removing.
Replace the gasket between the master brake cylinder and the brake booster.
CAUTION:
Risk of destroying the brake booster.
- Do not let any brake fluid run into the brake booster.
-- When inserting the brake master cylinder, make sure the push rod is seated correctly in the brake booster.
-- Install the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .
WARNING:
Risk of accident!
- Make sure the brakes are working correctly before driving the vehicle for the first time.