Brake Booster, Removing And Installing: Installing
Install in reverse order of removal and note the following:
Replace the nuts after removing.
Replace the seal between the brake booster and bulkhead.
The new seal is not bonded.
-- Remove any bonded joint residue from the brake booster and the bulkhead.
-- Using a hot air gun, warm the adhesive residue at a low setting and remove it.
-- Clean the surfaces thoroughly.
-- Attach the brake pedal to the brake booster. Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .
-- Follow the steps for connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Install the selector lever cable and the cable bracket. Refer to OVERVIEW - SHIFT MECHANISM .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Refer to HYDRAULIC SYSTEM, BLEEDING .
Risk of accident!
- Make sure the brakes are working correctly before driving the vehicle for the first time.