LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Antilock Brake System [Coupe]) >> 45 Antilock Brake System >> Control Module And Hydraulic Unit >> ABS Control Module -J104- / ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING >> ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, VEHICLES WITH A TDI ENGINE >> Notes

ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, VEHICLES WITH A TDI ENGINE: Notes

WARNING: This page is about a different variant/trim than selected.
NOTE:

If the ABS Control Module -J104- is faulty, the control module can be replaced separately.

If the ABS Hydraulic Pump -V64- faulty the ABS Hydraulic Unit -N55- must be replaced together with the ABS Control Module -J104-.

The ABS Hydraulic Pump -V64- cannot be replaced separately.

CONTROL MODULE, SEPARATING FROM HYDRAULIC UNIT 

NOTE:

OVERVIEW - CONTROL MODULE AND HYDRAULIC UNIT .

If the ABS Control Module -J104- / ABS Hydraulic Unit -N55- is being replaced, select the "Replace" function for the ABS Control Module -J104- / ABS Hydraulic Unit -N55- on the Vehicle Diagnostic Tester => , Guided Functions  .

Special tools and workshop equipment required 

  1. M10 Plugs
  2. M12 Plugs
scientia non olet · About LEMON Manuals