Parking Brake, Checking
WARNING: This page is about a different variant/trim than selected.
Activating >>T U V Mode<<
- The seat belt is buckled.
- Rear axle in the one-axle roller test stand
- The engine is off and the ignition is on.
- Auto Hold is off.
- The front wheels must be stationary.
- The rear wheel must rotate for at least five seconds non-stop between 2.5 and 9 km/h (2.6 through 5.6 mph)
>>T U V mode<< is indicated when the yellow Electric Parking/Hand Brake Malfunction Indicator Lamp -K214- is displayed.
-- The yellow electromechanical parking brake symbol with a line through it appears in the instrument cluster. Refer to the Owner's Manual, Instruments and Indicator Lamps.
NOTE:
The electromechanical parking brake does not close completely immediately in the >>T U V mode<<.
Operating the Electro-Mechanical Parking Brake Button -E538- three to four times increases the tension in stages.
Operating the Electro-Mechanical Parking Brake Button -E538- a fifth time loosens the electromechanical parking brake.
-- Start the engine and wait approximately five seconds until there is enough vacuum.
Ending >>T U V Mode<<
- Front wheels, speed greater than 0 km/h (0 mph)
- Rear wheels, speed less than 2.5 km/h (1.5 mph) or greater than 9 km/h (5.6 mph)
- Ignition off.