Left/Right Rear Level Control System Sensor -G76- / -G77-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
NOTE:
The level control system sensor lever must point toward vehicle exterior.
On vehicles with electronic damping (Audi magnetic ride), perform the "Readapt control position" function using the Vehicle Diagnostic Tester.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Chassis
- Wheel Damping Electronics
- 01 - OBD-capable systems .
- 14 - Electronic Damping Control Module -J250
- 14 - Electronic Damping Control Module, functions
- 14 - Readapt Control Position
- If the control position was reprogrammed on a vehicle with lane assist, then the driver assistance systems front camera must be calibrated. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
- Adjust the headlamps to the basic setting. Refer to HEADLAMP, ADJUSTING .