Left/Right Front Level Control System Sensor -G78- / -G289-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
NOTE:
The level control system sensor lever must point toward vehicle exterior.
The thread on the vehicle level sensor must be installed into the front hole in the control arm. The tab on the vehicle level sensor bracket must lock into the rear hole in order to assure a correct installation position.
On vehicles with electronic damping (Audi magnetic ride), perform the "Readapt control position" function using the Vehicle Diagnostic Tester.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Chassis
- Wheel Damping Electronics
- 01 - OBD-capable systems .
- 14 - Electronic Damping Control Module -J250
- 14 - Electronic Damping Control Module, functions
- 14 - Readapt Control Position
- If the control position was reprogrammed on a vehicle with lane assist, then the driver assistance systems front camera must be calibrated. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
- Adjust the headlamps to the basic setting. Refer to HEADLAMP, ADJUSTING .