Rain/Light Recognition Sensor -G397-, REPLACING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
CAUTION:
Risk of damaging the humidity sensor.
- The humidity sensor is very sensitive and must not be damaged.
-- Gently press the grip surfaces -arrows- on the protective cap -2- together and remove from the sensor -1-.
NOTE:
To avoid contaminating the silicone pad, remove the protective cap just before installing it.
-- Insert the sensor -4- into the mount -2-.
CAUTION:
The Rain/Light Recognition Sensor -G397- must not have any embedded objects or bubbles between it and the windshield so that it functions correctly.
-- Press on the clips -1 and 5- until they audibly engage.
-- Connect the connector -3-.
-- After replacing the rain/light recognition sensor, it must be re-coded in "Guided Functions" mode using the Vehicle Diagnostic Tester.