Overview - Starter, Vehicles With Dual-Clutch Transmission Version 1

WARNING: This page is about a different variant/trim than selected.

Fig 1: Starter, Vehicles With Dual-Clutch Transmission Version 1 Exploded View

Courtesy of AUDI OF AMERICA, LLC

Starter
- Removing and Installing. Refer to STARTER, REMOVING AND INSTALLING .
Bolt
- Tightening specification:
  - Bolted connection for starter to transmission: 40 Nm
Ground Wire
Nut
- 20 Nm
Connector
Nut
- 20 Nm
30/B+ Terminal
- with cap
Nut
- 20 Nm
Bracket
- for wiring harness
Bolt
- Depending on the version, installed on top or bottom
- Tightening specification:
  - Bolted connection for starter to transmission: 40 Nm