Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Pull on the connector to make sure it is locked secure.
-- Insert the Fuel Pump Control Module -J538- into the mount and press on it until it clicks into place.
Further installation is performed in reverse order of removal, while noting the following:
TT Coupe:
-- Install the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .
TT Roadster:
-- Install the right rear panel. Refer to the appropriate Service Information
-- Install the right rear panel trim panel. Refer to REAR PANEL TRIM PANEL, REMOVING AND INSTALLING .