EVAP CANISTER, REMOVING AND INSTALLING, VEHICLES WITH Fuel Tank Pressure Sensor - G400- / Fuel Tank Leak Detection Module - GX36-: Removing

WARNING: This page is about a different variant/trim than selected.

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .

Vehicles with Fuel Tank Pressure Sensor -G400-

-- Disconnect the connector -4- by unlocking the connector safety catch.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screw -1-.

-- Remove the EVAP canister -2- downward out of the mount -3-.

-- Disconnect the breather lines -5, 6- on the EVAP canister. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .

Vehicles with Fuel Tank Leak Detection Module - GX36-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bleeder line -2-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .

-- Disconnect the bleeder lines -3- on the EVAP canister. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .

-- Disconnect the connector -4- by unlocking the connector safety catch.

-- Remove the screw -1-.

-- Push the tabs -arrow- with a screwdriver and remove the EVAP canister -5- downward out of the retainers.