Ignition Coils, Removing And Installing: Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the nut -2- and free up the ground wire -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors and remove from the ignition coils at the same time -arrows-.

-- Insert the :T10530  in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC

-- Turn the knurled nut -2- clockwise in direction of -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically in direction of -arrow- using the :T10530  .

Fig 2: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC