Ignition Coils, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal while noting the following:
-- Apply a thin bead of silicone paste around the seal hose for the ignition coil with power output stage -arrow-.
NOTE:
Only the silicone paste may be used which is specified .
By not following this there is a risk of destroying the ignition coil.
-- Push the ignition coils evenly onto the spark plugs using by hand (do not use any impact tools).
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .