Engine Speed Sensor -G28-, REMOVING AND INSTALLING

Removing 

-- Remove the noise insulation (front). Refer to OVERVIEW - NOISE INSULATION .

-- Open the clip -2- and free up the coolant hose -1- and push to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clip upward from the air duct pipe.

Vehicles with Coolant Valve 

Fig 1: Transmission Coolant Valve -N488- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the nuts -arrows- and move the Transmission Coolant Valve -N488- to the side.

All Vehicles 

Fig 2: Identifying Engine Speed Sensor And Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the bolt -arrow- and remove the Engine Speed Sensor -G28-.

After removing or replacing the engine speed sensor the adaptation values for the chain length must be adapted again.

-- Connect the Vehicle Diagnostic Tester.

-- Select Diagnostic  operating mode and Start diagnostics  .

-- Select the Select individual test  tab and select the following tree structure consecutively:

• Drivetrain 
• Select the engine code and engine 
• 01 - OBD-capable systems  .
• 01 - Engine Electronics 
• 01 - Engine electronics, functions 
• 01 - Chain length diagnostic adaptation 

Tightening Specifications 

• Refer to OVERVIEW - IGNITION SYSTEM 
• Refer to OVERVIEW - COOLANT VALVES .
• Refer to OVERVIEW - NOISE INSULATION .