Camshaft Position Sensor -G40-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- Check the O-ring for damage.
-- Install the MPI fuel injectors with fuel rail. Refer to FUEL INJECTORS, REMOVING AND INSTALLING, MPI SYSTEM .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
After removing or replacing the camshaft position sensor the adaptation values for the chain length must be adapted again.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01 - OBD-capable systems .
- 01 - Engine Electronics
- 01 - Engine electronics, functions
- 01 - Chain length diagnostic adaptation