Calibration Tool : VAS6350, INSTALLING AND ALIGNING: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Calibration Unit: VAS6350A
- Vehicle Diagnostic Tester
The Calibration Tool: VAS6350 consists of the following parts:
- Calibration Tool - Wheel Center Mountings: VAS6350/1
- Calibration Tool - Spacing Laser: VAS6350/2
- Calibration Tool - Linear Laser: VAS6350/3
After performing service work on the vehicle, it may be necessary to re-calibrate the rearview camera system. In detail, this is the case after:
- Rearview Camera -R189- Removal and Installation
- Collision repairs on rear lid
- Changes to the axle alignment on the rear axle